Heatshrunk CSI Raspicam cable - FAIL!

The heatshrunk Raspicam cable is a non starter. The heatshrink became too hard and inflexible causing the cable to disconnect from the Pi sporadically, as such I am looking at other alternatives. This is a bit of a disappointment and will take the camera housing back to the drawing board too with not much time left, but the alternative being considered is use some clear nail polish on the spare Raspicam cable and obviously insulate the ends that go into the Pi Zero and into the camera housing/module with silicone and pray for the best.

As for the code part, it's all completed and an update will be due soon with the code some photos/videos.

Until next time,

Luis